Hi,
I would like to limit bandwidth for all traffic only for specific IP on my RV340. Is it possible? Can I do that using web interface?
I've tried in this way:
1) I've created traffic class named "Limit" for WAN1 ,and Destination IPv4 192.168.10.124/255.255.255.255, all traffic
2) next i've created new WAN Queuing entry "Rate_Control_LImit", where at first position i've choose "Limit" and set Minimum Rate and Maximum Rate to 1%
3) At WAN Policing i've checked Enable policing checkbox and set at first position "Limit" with Maximum Rate 50%
4) At Bandwith Management I've set for WAN1 "Rata_Control_Limit"
Now, I can't understand how it works: If at point 3) I set 50%, I can download data from internet with about 50% of bandwith, not 1% what is set in point 2) Why? If at point 3) I set 1%, I can downolad data with about 1% of available bandwith. So for what is min and max rate in WAN Queuing settings?
Best regards,
Mariusz