Meraki MX64 VPN Client

mr.sajid · ‎12-22-2021

Hi,

I have CISCO Meraki MX64 and "Client VPN" (under Security and SD-WAN) is configured properly. Hence I can connect and authenticated to it using VPN client from Windows 10. Everything works perfectly fine for a about half a minute but after that all traffic stops and I can't even ping or browse anything. What could be the reason for this issue?

Kindly suggest a solution.

Thanks a lot,

Sajid

marce1000 · ‎12-22-2021

- Check the logs on the Meraki-device , check if you can find anything that relates to your problem

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

mr.sajid · ‎12-22-2021

Thanks for your kind response. Nothing shows up in it's log which relates to this issue.

brywhite · ‎03-12-2023

This is still an issue for the MX95. The Windows native client VPN works, the Cisco Secure Client (legacy v5.0.01242) works, but the Cisco AnyConnect Client (Universal Windows Platform fpr Windows 10/11) available from the Microsoft Store does not. The client will connect and authenticate but disconnects after less than a minute w/o any error message or log entires.

STD_NetWorld · ‎04-12-2023

@mr.sajid Could you confirm few configuration on SD-WAN --> client vpn --> anyconnect setting ?

DNS nameservers
Client Routing
Dynamic Client Routing
Default Group Policy

And have you configured any policy for anyconnect Subnet on SD-WAN--> Firewall?