Route specific ip address to a specific wan port.

[wguitard1]

I use a router RV082 with load balancing. My problem is when I try to access a specific site, I get the error message that my IP address changes and I can not use 2 ip address. I want to specify an ip range to always use the same WAN port.

Can you help me with the configuration I have to do?

Thank you!

[Te-Kai Liu]

Dual WAN>Protocol Binding is the page you are looking for.

[wguitard1]

Thank you for your response. Can tell me how by an example, my attempts were unsuccessful.