RV042 Firewall Multiple external IP addresses

[racassel1]

Hi, I hope someone can give me an example of what I need to do, if possible with the RV042

Primary External IP address uses port forwards for some ports, all okay.

I would like to have other external ip addresses assigned to machines on my lan

Basic host multiple web servers, on different IP addresses, using port 80..

for example, 202.x.x.1 port 80 use port forward  to go to 192.168.168.1

                   202.x.x.2 port 80 use firewall rule to go to 192.168.168.2

                   202.x.x.3 port 80 use firewall rule to go to 192.168.168.3

                   all other ports should show stealth

                   (192.168.168.2 should show external address of 202.x.x.2 when going to whatismyip.com)

From what i am reading, it looks like the RV042 can do this, but I am not real clear what my rules should look like.

I would think my high priority rule for each external IP address would be to deny all traffic first for each machine on the lan.

Then create one entry with source 202.x.x.2 port 80 -> 192.168.168.2   ??

How shoud I set my rules to do this, and what settings should I have on the Nic of the second machine?

greatly appreciate it ,thanks!

[racassel1]

PS Everyting is working fine, except the default is all ports are default open for one-to-one nat.

I want to have all the ports closed, except a few.  The setup below does not seem work..

Priority PolicyName Enable Action Service Source Destination Time

1       CloseAll       enable DENY  all traffic wan1  192.168.1.189 always

2        HTTP           enable ALLOW       80  wan1 192.168.1.189 always

[Te-Kai Liu · Accepted solution]

The order of the two rules should be reversed.

[racassel1]

You are the man!  All about the priority, thanks.

Now if there was just a dummies manual for these routers, it would be great.  QuickVPN aint so darn quick with the innstructions that are given.  The documentation should be called, "clues" to setting up QuickVPN.