07-12-2012 09:44 AM
I have a few sites using the RV042 with wireless access points and some of them have over 50 devices.
In reviewing the documentation (specifically,http://www.cisco.com/en/US/docs/routers/csbr/rv0xx/administration/guide/rv0xx_AG_78-19576.pdf), I came across this:
Enable DHCP server: Check the box to allow the router to dynamically assign IP addresses to up to 50 connected devices. Uncheck the box if you have another DHCP server on the network or you want to configure static IP addresses for your network devices.
Is this accurate? Or will the RV042 allow more than 50 devices?
Thanks in advance.
DSB
07-12-2012 10:39 AM
You could always adjust the start/end IP address of the DHCP address pool to accommodate more clients up to 253.
50 is the default pool size.
07-12-2012 10:40 AM
Thanks for your reply. So the document is incorrect, or perhaps out of date?
07-12-2012 10:47 AM
You are right, David. I will pass it on to the product team.
02-07-2018 04:44 AM
Hi Te-Kai Liu,
This documentation page https://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=60258cca0efe4ff8a13dafd61f499a31_IPv4_DHCP_Server_Configuration.xml&pid=2&converted=0
still shows a limit of 50. You mentioned that you would notify the product team. Is there any update? As it is, your statement still conflicts with the published product documentation.
Thanks.
02-26-2018 08:35 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide