RV042G cannot use Cisco vpn client

[napaul511]

CISCO RV042G as router WAN  Interface(WAN Obtian ip automatic)     connect with another router

Computer behind  RV042G cannot connect Cisco Vpn client V5.0.07.0290     (CISCO software) to out side   but can use internet normally
RV042G firmware   lastest
v4.2.2.08


After I change RV042G to Linksys RV042 V1 old device same config <> computer can be use     Cisco vpn client connect to out side.
RV042 V1
   Firmware Version: 1.3.13.02-tm

It has bug in firmware v4.2.2.08

[Eric Moyers]

Hi, My name is Eric Moyers. I am a Network Support Engineer in the Cisco Small Business Support Center. Thank you for using the Cisco Community Post Forums.

Unfortunately the RV042G does not support the Cisco VPN Client and I am not sure how you got it to work with the older RV042 V.

If the RV042G was supported it would list it in te Data Sheet like it does here in the RV320

http://www.cisco.com/en/US/prod/collateral/routers/ps10907/ps9923/ps11997/data_sheet_c78-726132_ps9923_Products_Data_Sheet.html

I am sorry that this is not the answer you were looking for. but is Cisco VPN Client is a requirement the Small Business Routers that support it are the SA500's, ISA's, RV320 and RV325.

Thanks

Eric Moyers    .:|:.:|:.

Cisco Small Business US STAC Advanced Support Engineer

Wireless Subject Matter Expert

CCNA, CCNA-Wireless

*Please rate the Post so other will know when an answer has been found.

[anhhieuvn20082008]

but i see the review of rv042g say it support 50 tunel for client acccess ? ?