04-18-2018 09:22 AM - edited 03-21-2019 11:08 AM
Somebody can help me or share some links how to configure PAT on Cisco RV130 router? I read spec and its written there that RV130 supports PAT. But i couldn't find how to configure it.
Also is it possible to tunnel all traffic through VPN connection ?
04-19-2018 03:51 AM
Hi,
You can configure one to one NAT by using RV130 router. Please find the link below to configure the same :
Also you can configure and transfer the traffic using VPN in RV130 also. Please find the link below to configure the VPN :
04-19-2018 04:54 AM
Hi,
Thanks for your reply. But problems is:
For NAT i cannot use ip address that was provided me by ISP. When i type the ip address it says "IP address cannot be the same as the Router WAN IP address". What should i do ?
For VPN router allows me specify only specific IP address or range of addresses. I cannot type ip address 0.0.0.0 and mask 0.0.0.0 it gives me error "Not valid"
So how can i pass all traffic through vpn tunnel ? Not for specific IP addresses
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide