RV130 Point-to-Point VPN

johne5s010101 · ‎03-22-2016

Hello,

I have a new VPN to setup in a cisco rv130 to a remote 3rd party business that runs a server that we need to connect to. After I input all the VPN connection info and enable the tunnel I lose almost all LAN connectivity. I receive DHCP from the router and that's it. No Internet access. can't even ping or login to the router. I can ping across the VPN to the remote server. So the tunnel is up.

It seams that the vpn route has priority over the LAN. How do I change this? How do I only use the vpn to get to the remote server and leave the internal LAN alone.

I have defaulted the router and plugged in the vpn info with the same results.

i'm running the latest firmware 1.0.2.7

Thanks John

johne5s010101 · ‎04-04-2016

a new ver of the RV130 come out last week, Upgraded the router and still no help.

now the router is at 1.0.3.14

any help at all?

When ever I enable the Point to Point VPN, the router reverts all traffic across the vpn, how do I stop it from doing this?

John