I'm trying to set an IPSEC tunnel between two vpn router RV130 , VRA and VRB..
VRA is behind a tplink c1200 archer nat router , rA connected to a dynamic ppoe service.
VRB is behind a tplink c1200 archer nat router , rB connected to a static IP but through a ppoe service.
I've tried ping rB 's fixed WAN IP provided by the ISP through rA. Ping sucessful.
There's something however different about the connected WAN ip address from rB. It's different from the give Fixed IP by the ISP. I believed that the tplink nat router is a modified firmware as compared to the original c1200 archer. There're no options to set fix ip. The isp providers configure by enable the Dual Lan options and configured the fixed ip adress there under the DHCP menu. Though the LAN DHCP is entirely different form this DUAL Lan options.
Since both tplink archer c1200 are stated to allow IPSEC pass through.
I've tried vpn ipsec tunnel between the rv130 VRA and VRB without any success..
I wished to set services VLAN on rv130 accordingly to the ISP's services VLAN id number but there's no option to do so.
The only VLAN you can set is however the LAN vlan that caters to the LAN network only.
