RV180 Port Forwarding

[anaushahi]

I am trying to set up RV180 @ 2 locations. I have setup Port forwarding for Remote Desktop 3389 (Defined as a custom srvice), FTP and HTTP. When I try to access these services from within LAN it works fine, however from any other location only FTP works and RDP and HTTP are rejected. I have a static IP address. I have tried with both Port Forwarding as well as Access Rules. Please help ASAP.

Operation succeeded

Port Forwarding Rule Table

	Action	Service	Status	Source IP	Destination IP	Internal Port
	Always Allow	HTTP	Enabled	Any	192.168.2.50	80
	Always Allow	FTP	Enabled	Any	192.168.2.160	21
	Always Allow	RDP	Enabled	Any	192.168.2.163	3389

Access Rule Table

	Action	Service	Status	Connection Type	Source IP	Destination IP
	Always Allow	HTTP	Enabled	Inbound (WAN (Internet) > LAN (Local Network))	Any
	Always Allow	FTP	Enabled	Inbound (WAN (Internet) > LAN (Local Network))	Any
	Always Allow	RDP	Enabled	Inbound (WAN (Internet) > LAN (Local Network))	Any

[klp992001]

Hey Luis,

Well done for figuring that one! In the meantime, you may wish to see if your firmware needs updating as it appears newer firmware has fixed this problem.

[jtobia2005]

Update the firmware to the latest version (1.0.3.10 as of this writing). After reboot, delete the existing troublesome Fowarding rule(s), Custom service(s), and Access rule(s).  Once deleted and saved, manually add back the Forwarding and Custom services rule(s) and the Access rule(s) will be auto-created and auto-enabled this time and all seem to work now (finally).  This worked for me when following this order of steps.