RV220W not working with the PPTP server on one VLAN only

[Thierry CLAUSS]

Hello,

I possess a RV220W (firmware 1.0.3.5) but I can't seem to work with the PPTP server on one VLAN only.

My default VLAN is in 192.168.1.1/24.

I created a VLAN ID 10 in 192.168.50.1/24 inter-vlan routing : disabled and Device Management : disabled.

(Menu Networking > LAN > VLAN Membership and Multiple VLAN Subnets).

Then I configured a PPTP server on the IP range 192.168.50.200 to 192.168.50.210.

To finish I created my user.

(Menu VPN > IPSEC > VPN Users).

The PPTP tunnel is working, but on all my local network and not only the VLAN ID 10.

An idea??...

[Thierry CLAUSS]

HI,

Nobody can tell me if the RV220 PPTP server is able to work on a specific VLAN??.

[Te-Kai Liu · Accepted solution]

This seems to be a limitation of firmware 1.0.3.5. Firmware 1.0.4.x will support inter-VLAN access rules, which hopefully can be used to restrict traffic to the default VLAN from your VLAN ID 10.

[Thierry CLAUSS]

Thank you tekliu,

I eagerly awaiting the release of firmware 1.0.4.x

cordially

Thierry