10-06-2014 08:12 AM
Serial Number: | Firmware Version: | v1.1.1.06 (2013-12-06, 11:02:37) | ||
PID VID: | RV320 V01 |
Dear sir,
I got a issues, I have configure 2 VLAN on RV-320, VLAN 1 i have disable the DHCP, VLAN 25 i have configure DHCP Server enabled, but it seem DHCP bind on VLAN 25 is not working, then i try to config the static IP on device testing the VLAN is working, successful separate broadcast domain. and i can pint the VLAN 25 IP address, on DHCP i have re-enable VLAN 1 DHCP Server, it also working, successful assign the ip address to dynamic host.
any advise on my issues?
Thanks,
10-06-2014 06:23 PM
10-06-2014 06:39 PM
Yes,
you can assume my testing environment is only RV320 4 Switch Port,
port 1 untaged for VLAN25, exclude VLAN1 <- my VLAN25 Host connected on this port
port 2 untaged for VLAN 1, Tagged VLAN 25
port 3 untaged for VLAN 1, Tagged VLAN 25
port 4 untaged for VLAN 1, Tagged VLAN 25
any information need please leave me message here. thanks,
10-06-2014 08:33 PM
The only other thing that comes in mind is enabled Vlans under Vlan membership? Its at the top left corner with its own checkbox.
10-07-2014 12:24 AM
already enabled....
i have mention " then i try to config the static IP on device testing the VLAN is working, successful separate broadcast domain. and i can ping the VLAN 25 IP address "
clearly present it that is not VLAN configure problem............
Please advise ...thanks,
10-07-2014 10:02 AM
i had vlan disabled and vlan untagged for my RV320 in the lab, which would not hand out ip address for a different vlan. At this point at your earliest convenience open a support case so an engineer can look at the configuration in your router. If you like i can take a look at your config. Just send config to PM.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide