RV320 DHCP server

[echolai]

Serial Number:			Firmware Version:	v1.1.1.06 (2013-12-06, 11:02:37)
PID VID:		RV320 V01

Dear sir,

I got a issues, I have configure 2 VLAN on RV-320, VLAN 1 i have disable the DHCP, VLAN 25 i have configure DHCP Server enabled, but it seem DHCP bind on VLAN 25 is not working, then i try to config the static IP on device testing the VLAN is working, successful separate broadcast domain. and i can pint the VLAN 25 IP address, on DHCP i have re-enable VLAN 1 DHCP Server, it also working, successful assign the ip address to dynamic host.

any advise on my issues?

Thanks,

[Ismael Arroyo]

echolai@califor,

Did you untag  traffic for the interfaces on Vlan 25 under Vlan membership?

[echolai]

Yes,

you can assume my testing environment is only RV320 4 Switch Port,

port 1 untaged for VLAN25, exclude VLAN1   <- my VLAN25 Host connected on this port

port 2 untaged for VLAN 1, Tagged VLAN 25

port 3 untaged for VLAN 1, Tagged VLAN 25

port 4 untaged for VLAN 1, Tagged VLAN 25

any information need please leave me message here. thanks,

[Ismael Arroyo]

echolai@califor..

The only other thing that comes in mind is enabled Vlans under Vlan membership?  Its at the top left corner with its own checkbox.

[echolai]

already enabled....

i have mention " then i try to config the static IP on device testing the VLAN is working, successful separate broadcast domain. and i can ping the VLAN 25 IP address "

clearly present it that is not VLAN configure problem............

Please advise ...thanks,

[Ismael Arroyo]

echolai@califor,

i had vlan disabled and vlan untagged for my RV320 in the lab, which would not hand out ip address for a different vlan. At this point at your earliest convenience open a support case so an engineer can look at the configuration in your router. If you like i can take a look at your config. Just send config to PM.