RV320 stuck at firmware 1.3.2.02

[Martin23349]

Since 2018 I've got a RV320 router which has currently running firmware v1.3.2.02.

I tried to upgrade this several times before, but the upgrade does not seem to work.

Today I finally got round to looking into my firmware upgrade problem again.

What I tried:

• uploading the latest v1.4;
• uploading the latest v1.5;
• Upgrading via USB;

All upgrade methods seem to work, but after reboot the former version 1.3.2.02 is shown again.

Anyone any idea?

[marce1000]

 - Check the logs during the upgrade procedure or attach a console and follow up on it. Also keep checking for errors during the initial boot after the upgrade attempt.

 M.

[Martin23349]

Hello Marce1000,

Thanks for the reply. The logs are not showing anything. All boxes were ticked. 

Between loading the USB drivers and reboot nothing is added to the log.

2020-02-02, 04:46:32	Kernel	/sbin/usb_modem[3573]: 0x0781_0x5591-1.usb not exist
2020-02-02, 04:46:32	Kernel	/sbin/usb_modem[3573]: Unknown usb1 device(0781:5591), add vid/pid for driver
2020-02-02, 13:58:39	System Log	xlassist : System is up
2020-02-02, 13:58:39	System Log	Firmware Version : v1.3.2.02
2020-02-02, 13:58:40	Kernel	kernel: Init model[320-0] system information:

Never used a console before, so don't know where to start.

Can I do this by SSH? 

Regards, Martin

[marce1000]

                             >Never used a console before, so don't know where to start.

   - Check if there is a console port somewhere on  your device (sometimes marked blue - or consult device manual to find the console port); then attach serial cable ; usually uses 9600 baud. Then follow my instructions as stated in initial reply.

 M.

[Martin23349]

Hello M,

Too bad, no console port available on this router.

I'll give support a call tomorrow.

Martin