RV320 - Using Specific WAN Setting

[ericyim01]

Hi All,

I am new to RV320 and I would like to know that how can I set an IP address using specific WAN (say Wan 1) connection when load balance is enable.

Thanks,

Eric

[Aleksandra Dargiel]

Hi Eric,

You should be able to achieve it by using protocol binding settings:

Dual WAN--> click on WAN (1 or 2) icon --> scroll down to protocol binding --> add specific rule for all services where source IP address would be your particular LAN host IP (repeated twice if it is only 1 host) and destination 0.0.0.0 (repeated twice) choose desire WAN1 or WAN2.

I hope this helps,

Aleksandra