RV320 VPN setup

[pribyl001]

Hello, I have Cisco RV320 dual WAN VPN router. I want to setup VPN connection to connect with my notebook remotely to my office network.

I have setup WAN1, SSL VPN with guide on youtube.com but I doesn´t work for me. My internet setup is for WAN1 IP 10.5.93.246, gateway 10.5.93.245, with DNS1 10.255.255.10  and DNS2 10.255.255.20. But my public IP is different for example 92.52.168.523.

I have done my setup exactly as in Cisco youtube guide, but it doesn´t work for me. When I try to open page https:\\92.52.168.523:10443 on my notebook I get error page not found.... But ping to my public IP adress (92.52.168.523) works fine

What could be the problem?

Thanks for your answer

[cchamorr]

Hello,

The issue that you are describing means that your modem is working as a router providing private IP addresses to your router.

What is happening now is that your modem has the Public IP 92.52.168.523 and your router, which is the device that has all the settings, has a private IP address of 10.5.93.246 not reachable over the internet. When you try to go to HTTPS://92.52.168.523:10443, you are actually reaching the modem and no the router. Thats why it is not working.

What you need to do is to contact your ISP and ask them to "bridge" the modem so that when you look at the IP address of WAN 1 inside the router you will see the actual public address and not the private: 10.5.93.246.

I hope this helps