RV325 Dual WAN Router - Use only one IP

[michaelmuratovic]

I have a rv325 dual wan router. I have setup load balancing on the router, but I don't want one of the servers here being load balanced. How do i set it to only use a specific WAN while everything else is load balanced?

[michaelmuratovic]

I had figured out that i need to use the "protocol binding table" to do what I need done. Will i use the sever IP for the source and destination IP??

[Ismael Arroyo]

Michael,

I like to share link that will has a step by step screenshots on how to configure protocol binding. Your source ip will be server and Destination is whichever WAN you are shaping that traffic. Hope this helps

Article ID: 4242

http://sbkb.cisco.com