RV340 and SNMP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-21-2019 03:27 AM
I have a brand new RV340, did firmware upgrade to 1.0.03.15, reset to factory settings after upgrade.
I'm trying to monitoring it's interfaces, tried with Cacti and Zabbix, no success.
Debugging I find out that doing smnpget I can't see counters increasing over time, but when I run smnpwalk it seems that counters get updated. Even so, counter of In packets are the same of Out packets!
Does anyone know what is going on? Or how to debug?
- Labels:
-
RV340
-
Small Business Routers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2021 07:14 AM
hello my version is 10.0.03.22 and i'm having problems with zabbix too, graphics keep cutting all the time!
Before it was working normally!
Through snmpwalk I get a response from my router correctly! but on zabbix the graphics are failing!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2021 07:31 AM
I don´t have zabbix here to test, but it works on Cacti.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-12-2021 02:35 AM
Hi, Can you please give me OID for monitor RV340 WAN1 and WAN2 port? I'm trying many way to use SNMP such as scan all MIBS files or walk many of OID, not found something to report the traffic usage.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2021 03:28 AM
Hi, Yes Sure... I will arrange for you. And I bring it here.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2021 03:48 AM
Many thanks ;} I waiting for it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2021 04:06 AM
Hello friend, below is the requested information, I hope I have helped!
I used the "snmpget" command to get this information:
snmpget -On -v2c -c "Community" "IP" IF-MIB::ifOutOctets.[...]
IF-In
IF-MIB::ifInOctets.33 = WAN1
OID: .1.3.6.1.2.1.2.2.1.10.33
IF-Out
IF-MIB::ifOutOctets.33 = WAN1
OID: .1.3.6.1.2.1.2.2.1.16.33
IF-In
IF-MIB::ifInOctets.34 = WAN2
OID: .1.3.6.1.2.1.2.2.1.10.34
IF-Out
IF-MIB::ifOutOctets.34 = WAN1
OID:.1.3.6.1.2.1.2.2.1.16.34
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-15-2021 08:53 PM
Thanks for your advise. but I'm still cannot get any value from provided OID. There's my log.
- Scan single OID. 1.3.6.1.2.1.2.2.1.10.33
16/11/2021 11:49:57 (2 ms) : SNMP V2c
16/11/2021 11:49:57 (2 ms) : Custom OID 1.3.6.1.2.1.2.2.1.10.33
16/11/2021 11:50:02 (5015 ms) : SNMP Datatype: ASN_PRIMITIVE
16/11/2021 11:50:02 (5018 ms) : -------
16/11/2021 11:50:02 (5020 ms) : Value: No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003)
16/11/2021 11:50:02 (5021 ms) : Done
- Walk 1.3.6.1.2.1.2.2.1.10
16/11/2021 11:50:26 (3 ms) : SNMP V2c
16/11/2021 11:50:26 (4 ms) : Walk 1.3.6.1.2.1.2.2.1.10
16/11/2021 11:50:31 (4543 ms) : 1.3.6.1.2.1.2.2.1.10.2 = "0" [ASN_COUNTER]
- Walk 1.3.6.1.2.1.2.2.1
16/11/2021 11:51:31 (4 ms) : SNMP V2c
16/11/2021 11:51:31 (5 ms) : Walk 1.3.6.1.2.1.2.2.1
16/11/2021 11:51:36 (4597 ms) : 1.3.6.1.2.1.2.2.1.1.2 = "2" [ASN_INTEGER]
16/11/2021 11:51:36 (4620 ms) : 1.3.6.1.2.1.2.2.1.2.2 = "WAN1-PPPOE" [ASN_OCTET_STR]
16/11/2021 11:51:36 (4645 ms) : 1.3.6.1.2.1.2.2.1.3.5 = "160" [ASN_INTEGER]
16/11/2021 11:51:36 (4671 ms) : 1.3.6.1.2.1.2.2.1.4.2 = "1500" [ASN_INTEGER]
16/11/2021 11:51:36 (4691 ms) : 1.3.6.1.2.1.2.2.1.5.2 = "0" [ASN_UNSIGNED]
16/11/2021 11:51:36 (4752 ms) : 1.3.6.1.2.1.2.2.1.7.2 = "1" [ASN_INTEGER]
16/11/2021 11:51:36 (4786 ms) : 1.3.6.1.2.1.2.2.1.8.9 = "1" [ASN_INTEGER]
16/11/2021 11:51:36 (4850 ms) : 1.3.6.1.2.1.2.2.1.10.2 = "0" [ASN_COUNTER]
16/11/2021 11:51:36 (4872 ms) : 1.3.6.1.2.1.2.2.1.11.2 = "0" [ASN_COUNTER]
16/11/2021 11:51:36 (4987 ms) : 1.3.6.1.2.1.2.2.1.14.2 = "0" [ASN_COUNTER]
16/11/2021 11:51:36 (5054 ms) : 1.3.6.1.2.1.2.2.1.16.2 = "0" [ASN_COUNTER]
16/11/2021 11:51:36 (5073 ms) : 1.3.6.1.2.1.2.2.1.17.2 = "0" [ASN_COUNTER]
16/11/2021 11:51:36 (5174 ms) : 1.3.6.1.2.1.2.2.1.20.2 = "0" [ASN_COUNTER]
