RV340 - Route all traffic to WAN1 for 1 private IP

[macfan007]

Here is setup 

2 ISPs are connected to 2 WAN Ports using PPOE connection. 
MULTI WAN enabled with Load Balancing. 

I'm unable to assign a specific private IP or a pool of private IPs to use either WAN1 or WAN2 (Only). Is this possible with the RV340? Any assistance would be appreciated. Thanks

[marce1000]

  - I don't think this is possible  : ref https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/KMGMT-1568_WAN_Load_balancing_on_RV340_Router.html
       >...Outgoing network load balancing is performed on a per IP connection basis; it is not channel-bonding, where a single connection uses multiple WAN connections simultaneously.

                             But there is no provisioning mechanism to select which IP goes to which interface , 

 M.

[macfan007]

@marce1000 What about Policy Binding ? Will it help ?  

[marce1000]

   - Looks like it , checkout : https://community.cisco.com/t5/routers-small-business/how-to-configure-policy-binding-table-for-rv340-router-series/m-p/4483103#M42061

 M.

[macfan007]

Seems it worked. I assigned one private IP/32 to Wan1 for all types of data.