cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1388
Views
0
Helpful
3
Replies

RV340 SSLVPN Errors - Clients keep dropping connections

Getting the following errors when clients are not staying connected to SSLVPN:

2019-Nov-26, 10:54:58 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.3335[74FB8470] nonblocking_ssl_write: Inactive sslserver connection context 0x00088F88;
2019-Nov-26, 10:54:58 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.3378[74FB8470] nonblocking_ssl_write: Invalid sslserver connection context 0x00088F88;
2019-Nov-26, 10:44:25 CST
error
ssl-vpn
log_sslvpnac: Last message 'facility=SslVpn;msg=' repeated 6 times, supressed by syslog-ng on router0DE2DA
2019-Nov-26, 10:39:25 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.3335[757B8470] nonblocking_ssl_write: Inactive sslserver connection context 0x00088AD8;
2019-Nov-26, 10:39:25 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.3378[757B8470] nonblocking_ssl_write: Invalid sslserver connection context 0x00088AD8;
2019-Nov-26, 10:37:45 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.2370[6E2FF470] connection_thread: Error accepting SSL connection;
2019-Nov-26, 10:37:45 CST
error
ssl-vpn
log_sslvpnac: facility=SslVpn;msg=ERROR sslserver.c.3146[6E2FF470] nonblocking_ssl_accept: Peer closed connection during SSL handshake,status:0;
3 Replies 3

madmax2018
Level 1
Level 1

Were you able to resolve this issue?  I have an RV340w with two issues I cannot figure out.  Using the Cisco Anyconnect latest version.

 

1) Split tunneling is not working when connected to the VPN.

2) About once or twice a day I need to reset the SSL VPN service on the router because users can no longer access the Internet.

 

Thanks

I am also having this issue.  Did not have support on the device so we purchased a new RV340 and still have the same issue.

RAHULBWC
Level 1
Level 1

I am facing this issue post upgrade to latest firmware.. 

Last time by rolling back the Firmware, I could resolve issue