cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7029
Views
0
Helpful
16
Replies

Site to Site VPN RV042

unleashed186
Level 1
Level 1

Hi Please could someone help me regarding my ISSUE with VPN site to site.

I have setup gateway to gateway unfortunetly I don't have any Static IPs so I setup 2 DynDNS.org Accounts at both Sites. Both RV042 Connect to another Router/Modem .

I have set them both as Router in the Router Mode and not as Gateway.  On the VPN Tab the Status just stays at "waiting for connection" I can see the correct Dynamic IP for the remote connection in the main and remote site of the other.  I can ping both dyndns names as well.  But can't connect...

The VPN log states the following.

ERROR: asynchronous network error report on eth1 for message to  105.237.1.xx port 500, complainant 192.168.137.153: No route to host  [errno 148, origin ICMP type 3 code 1 (not authenticated)]

With this being the main site and 192.168.138.0 the remote site, main site has a subnet of 192.168.137.0

Please could someone help me or point me in the right direction? Thanks In advance.

16 Replies 16

Thanks Tom

Just to recap quick the ip I need to forward to is the  WAN IP not the RV042 IP? In my case ie site one is 192.168.138.254 as  LAN IP and 192.168.138.101 as WAN ? Correct?

Hi Tom

I still can't access it remotely this is very Strange, I have Setup port forwarding at the one site for a DVR and can connect perfectly to it using Dyndsns remember I am using both sites as dynamic IP.  Very strange also setup RDP at both sites and port forward to a server at each site and can RDP to both using there dyndns names....