Teething issues with RV110W

[alex]

Just thrown out the old Vigor 2830 router as the firewall/port-forwarding functionality seemed to be fundamentally broken.

Now I've got an RV110W and it's looking encouraging, but...

I want to set up a firewall rule to give my VPN user full access to our LAN.

I can create an access rule in the firewall section, there's something very odd indeed about the "Destination IP" select control. It says "Single Address" and I can't change it.

BUT, if I cut and paste that screen here, look what it shows! Extraordinary!!!

Connection Type:	Outbound (LAN > WAN) Inbound (WAN > LAN) Inbound (WAN > DMZ)
Action:	Always block Always allow Block by schedule Allow by schedule
Schedule:
Services:	All Traffic DNS FTP HTTP HTTP Secondary HTTPS HTTPS Secondary TFTP IMAP NNTP POP3 SNMP SMTP TELNET TELNET Secondary TELNET SSL Voice(SIP) AppServer
Source IP:	Any Single Address Address Range
Start:	(Hint: 192.168.1.100 or fec0::64)
Finish:	(Hint: 192.168.1.200 or fec0::c8)
Destination IP	Any Single Address Address Range
Start:
Finish:
Log:	Never Always
QoS Priority:	1 (lowest) 2 3 4 (highest)
Rule Status:	Enable