cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
412
Views
5
Helpful
3
Replies

Why speed of Lan port not reach to 1000Mbps

manenigma
Level 1
Level 1
 

LanStatus.JPG

RV325 with FW RV32X_v1.5.1.13, Please help me to solve this issue.

3 Replies 3

marce1000
VIP
VIP

 

  - Depends , what is connected to it ? And what is the network capacity of  those devices ?

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

nbutlev
Cisco Employee
Cisco Employee

Hi,

 

My name is Nikola and I'm a SBD team member.

 

You may try with any of these actions:

 

Disable flow control v LAN-Port Settings on WAN interface. 

Disable PnP in System Configuration. 

Disable Policy Based Routing in Multi-WAN. 

Disable Network Service Detection.

 

Regards,

Jitendra Kumar
Spotlight
Spotlight

Speed totally depends on the opposite device what speed is set there and what that device auto-negotiate.

 

if you are not sure about that then check with another device that supports 1G and connect with the router you will get an auto-negotiate 1G by default.

 

As your snap shows some devices are connected on 1G.

Thanks,
Jitendra