I’ve got a few questions id really appreciate some help with,
so my company has just order our new broadband with is an EFM (Ethernet first mile) setup
the service is completely managed which is fantastic, however, I’ve been given a port to use on their cisco series 800 router which i am told all traffic will pass through this port.
from here i have been told i need to configure N.A.T to allow my internal network to work correctly.
I’ve got a WRP400 router
Dell server running Server 2008R2
so the internal network was already pre-configured when i started the company, the server has a default ip of 192.168.1.2
there current modem is set to 192.168.1.1
all PC's obtain their IP address from the server via DHCP and all is working fine. no problems until this EFM system went in.
so our ISP gave us the following
gateway address 62.x.x.x
subnet 255.255.255.248
a set of 5 usable IP's
DNS address.
so my questions is how do i setup this router to enable N.A.T so our internet network can still use the ip range it is currently on and connect to the internet through this EFM system??
any help would be appreacheated
Regards
Matt
