1841 show dsl interface command

[johnlloyd_13]

hi all,

i'm trying to troubleshoot one of our site today and can't seem to issue the show dsl interface command on a 1841 router. could someone advise if the same command is used for SHDSL or am i running with an IOS bug? thanks in advance!

#sh dsl? 

% Unrecognized command

#sh ver

Cisco IOS Software, 1841 Software (C1841-BROADBAND-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Wed 13-Aug-08 15:42 by prod_rel_team

#sh inv 

NAME: "chassis", DESCR: "1841 chassis"

PID: CISCO1841         , VID: V05 , SN: FHK13212639

NAME: "WIC/HWIC 0", DESCR: "WAN Interface Card - ATM (With multi line G.SHDSL module)"

PID: WIC-1SHDSL-V3     , VID: V02 , SN: FOC132041KD

[darrenflynn · Accepted solution]

been a while since I touched these but from memory I think its show controller dsl x/x

[Sandeep Choudhary · Accepted solution]

Have you tried this:

Have  you tried this::::show dsl int atm <>

or  

                               Show controller dsl <>

Regards

Please Rate if it helps.

[johnlloyd_13]

Hey guys,

Thanks for your inputs! I think I remembered using the show controllers command but it's not there. I'll check this router again when I get back to work.

Sent from Cisco Technical Support iPhone App

[johnlloyd_13]

guess it was there all along. maybe i've got used to the show dsl int on our 800s.

#sh controllers dsl   

DSL 0/0/0 controller UP

Globespan xDSL controller chipset

Line Mode: Four Wire Enhanced

DSL mode: Trained with SHDSL Annex B

Frame mode: Utopia

Configured Line rate: 4608Kbps

Line Re-activated 0 times after system bootup

LOSW Defect alarm: ACTIVE

CRC per second alarm: ACTIVE

Line termination: CPE

FPGA Revision: 0xB3