Routing

Hi All,  We deploy Cisco Router 2921 at company edge, it has two internet link connect.Gig0/0 was Fix Public IP:219.134.186.XGig0/1 was connect ADSL moden, dialer0 IP was dynamic.  Like the topology, we configure inside traffic load balance to intern...

Hi Friends,Please helpI have one server in DMZ which is 10.129.50.4 and from internal Lan 10.128.1.0 I can ping to that server. Now we got two more servers in DMZ which is 10.129.50.5 and 10.129.50.6 which is connected to the same switch as the first...

Hello all,                I have core router in ISP and it have 2 Gig link for another router one is main and another is backup.these link are directly connected with Core router and connected to another router with a Switch.So can we use the PFR in ...

                   Hi guys im new here, not sure if im posting in the right area... here i go.So ive got a wired connection (fibre 100mb/50mb) connected to my Cisco DPQ3212 works great, however i have 3 other PCs that need internet alsoi was looking ...

Hi Team,I am facing low relaiblity issue in one of the ethernet port even no link is connected to that port.is that a harware issue?=============================================================================Router model : cisco 3660IOS - c3660-ik8s...

I have a customer with a 2800 series router, 3560x switch, and various other switches. They have requested to VLAN the network from voice and data. The only problem is the phone system they have talks over two different PPP to a remote sites. How can...

Hello,I know it might seem like a novice question but I have this other engineer who's been doing this for years and for some reason we have a customer who has an ACL on his router to permit certain public ip's to his trixbox. However I took a look a...

Hello all,             I have cisco 7600 core router in ISP , i want to put the bandwidth limit on it for outgoing traffic (for internet) on a subnet because i am using Bluecoat and i want to test my bluecoat.On this subnet i have no limit for blueco...

Guys,I have a question regarding PBR that i have set up and the packet forward behaviour that is confusing me..Setup as below[Network A]--- Router with PBR---- Router with PBR----- Switch with PBR ----- (Interface a shared Trunk)Cisco ASA (multiconte...

Hi folks,I have a Cisco 3750 switch stack and am performing QOS against a number of SVI vlans on per customer basis.  I have 8 customers, each with a /29 public subnet and each with an SVI as a gateway within that /29 range.  I then have a "routable"...

HiWe've purchased a couple of Cisco 887w routers, and I've noticed that the wireless module (AP801) keeps rebooting itself approximatley every couple of hours. The 887 router remains up but the AP801 module reloads.In the show ver the reload reason i...

hi,I have seen this config on the internet and wondering is this correct ?say for example we have two company A and B. Company A is running ospf all in the  backone area 0Company B is also running ospf in backbone area 0now there is a  link from comp...