03-16-2007 03:40 AM - edited 03-03-2019 04:11 PM
Hello,
I have a new 2811 with an PRI ISDN card installed (NM-1CE1B=) and can not seem to enable and configure it. I have tried the usual commands:
card type e1...
controller e1...
...but neither are accepted. It wont even accept configuring ISDN switch-type global commands. It doesn't appear to accept any ISDN commands at all. I have tried 2 differenet IOS levels which both state they accept ISDN:
Cisco 2811
c2800nm-advipservicesk9-mz.124-3g.bin
c2800nm-adventerprisek9-mz.124-9.T.bin
Can anyone advise a level of IOS to use pleased?
rgds
Phil
03-16-2007 05:12 AM
I think this card is not supported on your router:
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b1150.shtml
http://www.cisco.com/en/US/products/ps5854/products_qanda_item0900aecd80169bd6.shtml
03-16-2007 05:55 AM
Thanks for this link - looks like it's not supported.
Phil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide