4510 connecting through swan

[dhanikonda]

Dear All,

I have cisco 4510 core switch in my network now we are planning to connect SWAN to the core switch,swan admin given one ip 10.10.1.128/24 .

now i have to configure core switch.For swan what type of configuration is required.

i will create separate vlan and it has to route through my firewall.

plz any one help me swan is new concept to me.

Thanks & Regards

Srinivas

[blau grana]

Hello dhanikonda,

By SWAN, you mean Satellite WAN, right?

I do not think that there should be some specific port configuration on your switch. But you should be aware of some rules which apply according satellite communication.

- link quality degradation during bad weather condition

- theoretical minimum delay over satellite link 240ms(one way), latency 480ms(two way) so some timer modification would be required

But I am no expert in this area, so maybe someone on forum can explain better.

Best Regards

Please rate all helpful posts and close solved questions