After applying the license on CSR1000V it is showing as active but not in use

[sudheer.yalla]

I have installed a CSR1000V on a Linux virtalization and given 4 CPUs, 10 GB of RAM, then activated the license as per the procedure. but in the license details command output is is showing as active & not in use. Please suggest me on the same.

show platform hardware throughput level
The current throughput level is 1000 kb/s

show license detail
Index: 1 Feature: sec_1G Version: 1.0
License Type: Permanent
Start Date: N/A, End Date: Jan 08 2021
License State: Active, Not in Use
License Count: Non-Counted
License Priority: Medium
Store Index: 0
Store Name: Primary License Storage

[Georg Pauwen · Accepted solution]

Hello,

have you set the

license boot level

followed by a reload ?

[sudheer.yalla]

yes, we have followed the same procedure mentioned in below link
https://www.cisco.com/c/en/us/td/docs/routers/csr1000/software/configuration/b_CSR1000v_Configuration_Guide/b_CSR1000v_Configuration_Guide_chapter_01000.html#d23903e2046a1635

[Georg Pauwen]

Hello,

just to be sure, did you use the

license boot level

command in global config mode ?

CSR100V(config)#license boot level