ASR1000-SIP10 Insertion Install

[Patrick McHenry]

Hi,

I'm installing a new ASR1000-SIP10 module/blade into a 1006 router. The module will have a 2 DS3 interafce card. I'm looking for a installation doc for the module. I'm sure it is fairly straight forward but, don't want to miss anything.

Also, when I install the module, will there be any configuration for it or will all of my configuration be for the DS3 interface?      

Thanks, Pat.

[Raju Sekharan · Accepted solution]

It is straightforward as you mentioned

Here is the doc for OIR for SIP

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/install_upgrade/ASR1000/ASRmin.html

Check the sttaus of the PWT and STAT LEDs one you install the SIP

"Showe platform" command will show you once the SIP module has come up

For ASR1000-SIP10, minimum required IOS is Cisco IOS XE Release 2.2

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/install_upgrade/ASR1000/ASRmov.html

Thanks

Raju