ASR1001-X - Issues to activate 10gig throughput license

[alexdelangel]

Hi Team,

I'm facing some issues to get the 10gig throughput license activated on an ASR1001-X. I have already ran the command license install ftp://xxxxx:xxxxx@X.X.X.X/license_file.lic, but the show license output still displays Active, Not in Use. Any ideas? Please see below:

Index 29 Feature: throughput_10g
Period left: Life time
License Type: Permanent
License State: Active, Not in Use
License Count: Non-Counted
License Priority: Medium

Thank you in advanced

[Georg Pauwen]

Hello,

I think you have to use the 'license boot' command, or the 'license clear' command, which then should prompt you to accept the EULA.

[alexdelangel]

Hi,

Thanks for the answer, but the license boot command doesn't display the throughput_10g feature, please see below:

Router(config)#license boot level ?
  adventerprise  Advanced Enterprise License Level
  advipservices  Advanced IP Services License Level
  ipbase         IP Base License Level

ZALDA12-R14(config)#license boot suite ?
  AdvUCSuiteK9       Advance UC Suite
  FoundationSuiteK9  Foundation Suite

I have done the license clear, but still appears as Active, not in Use, please see below:

Index 29 Feature: throughput_10g                 
        Period left: Life time
        License Type: Permanent
        License State: Active, Not in Use
        License Count: Non-Counted
        License Priority: Medium

Regards,

[Georg Pauwen]

Hello,

weird. The only thing I can think of is to accept the EULA...

conf t

license accept end user agreement

Which file is in your bootflash ? Make sure you have loaded the proper image, which usually is the K9 image:

bootflash:/asr1001-universalK9.03.10.01.S.153-3.S1-ext.bin.