We have configured site-to-site VPN connection with our remote client. While setting up phase 1 and phase 2 client had asked to send specific NATTED IP so to achieve this we added the natted IP in interface loopback5 at my router csr1000v.
We have configured loopback interface in our router and wanted to send all our packet to connect remote site using same.
For example:- If we want to telnet port 7010 at remote client IP 10.192.78.21 we need to run below command on our router telnet 10.192.78.21 7010 /source-interface loopback 5
So we wanted to forward all inbound traffic of our router coming from EC2 instance using above loopback interface to remote client such that it acts as a gateway.
How should I configure routing rules.