hello everyone. i am new to networking and facing some issues while practising in gns3. I am using static routes between ebgp peers to form neighborship. neighborships are done with loopback interfaces and i have end to end reachability. but when i manually shut down serial interface between r1 and r2, static route pointing towards r2 is not removed from from r1's routing table even if next hop is not reachable. so i am getting flapping neighborship between r1 and r2 when serial int between them is down. sometimes r1 can ping r2 via r4 sometimes it cant.
so how to remove static route if next hop is unreachable?
i want to configure the network as even if link between r1 and r2 goes down. r1 will still be able to talk to r2 via r4.
is another way to configure this network? only condition is ebgp neighborship must be form with static routes(i.e. no igp between ebgp peers) and when link between r1 and r2 goes down , r1 should still be able to ping to r2 via r4
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced in...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 22.214.171.124 as the RP for these groups:126.96.36.199/32188.8.131.52/32184.108.40.206/24220.127.116.11/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...