07-10-2023 09:49 AM
Hi, I've had a look around and can't seem to find my answer so here goes.
Long story short but with a C1111-8P is it possible to have ports Gi0/0/0 and/or Gi0/0/1 act as switchports, or be bridged to the switchports on the C1111-8P.
Reason for asking is I'm wanting to use one as a means to supply additional LAN ports, in place of a switch. The uplink I have is fibre, currently presented to a media convertor, then to a small switch.
The plan is to have the fibre present on Gi0/0/0 on the C1111-8P and then have 8 ports for use on the desk.
I know this sounds like I'm trying to hammer a square peg into a round hole. I'm just trying to make use of what I have at my disposal without needing to purchase anything else.
If it can't be done, without NAT or routing (yes I know the C1111-8P is a router not a switch) then it can't done. At least I'd have tried, thanks.
07-10-2023 10:06 AM
The only option I see is add the module EHWICs which is not your case as you told already and one last attempt I would try is get in one of those ports and issue "switchport". I dont believe it will accpect the command but if does it would be how turn the port from Layer3 into Layer2.
07-10-2023 12:18 PM
That was my first thought, but having tried the command 'switchport' on Gi0/0/0 and Gi0/0/1, both reject it.
Thanks for the suggestion anyway.
07-10-2023 12:25 PM
so there is one L3 and other L2 port,
try bridge using BDI between both port
if not success try BDI between VLAN and port
07-11-2023 08:58 AM - edited 07-11-2023 08:59 AM
07-11-2023 09:02 AM
I Think you config is correct.
Just one point which I will check tonight.
Thanks
MHM
07-25-2023 05:27 AM
Did you get a chance to check this? I'm still not able to bridge the two routed ports with the 8 switch ports.
Thanks again for looking into this more me.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide