cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
429
Views
0
Helpful
4
Replies
alalem2010
Beginner

can't load new image

hii guys 

I intend to upgrade the IOS of C1111 router , I downloaded a new image (the existing one is “Cisco IOS XE Software, Version 16.10.3a”) and I put it in the flash:, but when I wanted the prompt to start from the new image , I did not find the command “boot system” , it says “syntax error: unknown command”

 

How can I load the router from new Image ?

 

regards

4 REPLIES 4
Leo Laohoo
VIP Community Legend


@alalem2010 wrote:

“syntax error: unknown command”


The only time this error message comes up is when the router is running SD-WAN image. 

Converting the router from SD-WAN to autonomous is not easy.  

1.  Issue the command "controller-mode disable" to force the router to go into autonomous mode. 

2.  Delete all SD-WAN related files.  (Note:  Failure to delete SD-WAN related files will cause the router to boot back into SD-WAN.)

del /force /recursive bootflash:*sdwan*
del /force /recursive bootflash:vmanage-admin
del /force /recursive bootflash:.cdb_backup

3.  Upgrade the firmware (Cisco ISR & ASR 1k Routers: IOS-XE/Firmware Upgrade (Install Mode))

 

alalem2010
Beginner

sir @Leo Laohoo , after i upgrade i want to use it with SD-wan system 

alalem2010
Beginner

Dear Leo , i want to upgrade IOS and use router with SDwan system ,  new ios is already existing in bootflash: 

how can i make the router boot from 16.12.4 ios instead of  16.10.3a

@Leo Laohoo 

Spoiler
 

routerconfig1.pngrouterconfig.png

Leo Laohoo
VIP Community Legend

Has anyone read the Release Notes for SD-WAN?  
The upgrade procedure is there.