cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
317
Views
1
Helpful
3
Replies

Can't ping to MGMT VLAN Interfaces

izhangghani
Level 1
Level 1

izhangghani_0-1703844845279.png

Hi Team,

I have a problem that I can't do ssh to these switches (mark red), but I can do ssh to these multilayer switches (mark green). Anyone have the same issue with me?

The background is that all of these devices must be remote controlled from a laptop PT VLAN 200 with interface MGMT (VLAN 100). Please i need help for this because I'm very stuck

 

1 Accepted Solution

Accepted Solutions

M02@rt37
VIP
VIP

Hello @izhangghani 

Switches "red marked" need an ip default-gateway. You configure that ?

All switches, MultiLayer and L2, have a vlan interface (svi) in Vlan 100. L2 switches must have default-gateway pointing SVI100 hosted on their respective MultiLayer Switches, through the Trunk.

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

View solution in original post

3 Replies 3

M02@rt37
VIP
VIP

Hello @izhangghani 

Switches "red marked" need an ip default-gateway. You configure that ?

All switches, MultiLayer and L2, have a vlan interface (svi) in Vlan 100. L2 switches must have default-gateway pointing SVI100 hosted on their respective MultiLayer Switches, through the Trunk.

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

Thanks for helping me; I missed this one. Right now, it's clear, Thank you

You're so welcome @izhangghani 

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.
Review Cisco Networking for a $25 gift card