cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1852
Views
0
Helpful
5
Replies

catalyst 9500 xconnect with vrf issue

tikshoret
Level 1
Level 1

we have two catalyst pers of 9500-48yc that act as stackwise and that connected between them with macsec

and we have config  multiple vrf that are routable 

but when we config xcoonect per vrf

so the default vrf its come up

but the seconed vrf doesnt

i attached the configuration

remark** they are connetcted in my lab so no isp its involved

they connected through interface HundredGigE1/0/49 and hundergige2/0/49

 

what we are missing?

5 Replies 5

there is no config 

 

thanks

i upload now

balaji.bandi
Hall of Fame
Hall of Fame

When you compare information -

1. need to check the routing table from VRF are you able to reach other side.

2. Does your provider offer MTU9K , (this was noticed working vs not working ?)

3. run some debugging and see what causing the issue ?

4. another side of the interface does not belong to VRF?

since you mentioned same config working, so I have not fully validated the confg.

reference :

https://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/mpls/212979-xconnect-over-vrf-aware-l2tpv3-in-asr1k.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

1. the routing its ok per vrf

we have ping grom loopback to loopback and they are the same vrf

2.its now in our lb with no provider.. so the mtu its just playing and we try witjh 1500 its still doesnt work

4.its belong the same vrf

but its still doest come up

what if you move other interface to Default and move default to other VRF is this works ?

what is other side, 

enable debug and check what causing this issue ?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help