Cisco 867 Switch mode only?

[Tim Roelands]

Hi,

Is it possible on a Cisco 867 to configre each port individualy, or only by using Vlan's? Everytime I try to assign a IP to an individual port I get the message: 'IP Address may not be configured on L2 links'. I have tried the following:

# Config Term

#(C) Interface FastEthernet0

#(C-if) no switch access Vlan 1

#(C-if) ip address 192.168.1.1 255.255.255.0

'IP Address may not be configured on L2 links FastEthernet0

Thanks

[Leo Laohoo]

Errr ... What are you trying to achieve?  The Cisco 867 is a 4-port (layer 2 only) switch with an ADSL/ADSL2+ WAN variety.