01-17-2012 10:16 PM - edited 03-04-2019 02:56 PM
Hi
I have a Cisco 876 router, I need to connect ethernet WAN link, While configuring IP address am getting below error.
yourname(config)#int f0
yourname(config-if)#ip addres 172.30.1.0 1. 255.255.255.0
% IP addresses may not be configured on L2 links.
PFA of show tech-supp
Please help me
01-17-2012 11:37 PM
Hi,
The device's FE ports are Layer 2 only and it's used for the LAN. Use the ADSL (POTS) for your WAN connection.
Sent from Cisco Technical Support iPhone App
01-18-2012 12:00 AM
Hi
Thanks for the reply
But I need to connect two WAN links, there is only one ADSL port available with the router.
Can I connect by creating two seperate VLANs(SVI) with WAN IPs and add these L2 ports to the VLANs.
Will it work.
01-18-2012 05:12 AM
Hi Naresh,
Actually the Cisco 876 router has the following ports on the back panel:
Four 10/100BASE-T RJ-45 Fast Ethernet LAN ports with a built-in switch
One 10/100BASE-T RJ-45 WAN Fast Ethernet port
One ISDN S/T port
One ADSL-over-ISDN port
One RJ-45 console port
If the another wan link is ISDN type then you can use the ISDN S/T port it seems.
Connect the wan link to any interface then create a vlan and assign the wan link IP and do routing as possible.
I think so the above should work, because I have the same kind of setup. What I did is...
I have connected the WAN link to L2 port and create a vlan in router for the routing purpose.
Please rate all the helpfull posts.
Regards,
Naidu.
06-10-2014 12:46 PM
This is NOT correct - there is NO FE WAN INTERFACE on the Cisco876.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide