Hello,
I have a Cisco router 2600, which I use for my training lab setup. I typed write erase to start up a new configuration but the router did not come backup. I have an identical router and tried swapping flash and dram, but it did not work. Please I'd like to know if there's a way to get a prompt command back. The router keeps its ios loading in a loop, as show below.
Thank you in advance.
Self decompressing the image : ########################################################################################################################## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
000093 0X000A6200 C2600 Single Ethernet, Single Token Ring
0X00098670 public buffer pools
0X00211000 public particle pools
TOTAL: 0X0034F870
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 4Mb.
Using 12 percent iomem. [4Mb/32Mb]
%SYS-3-IMAGE_TOO_BIG: 'flash:c2600-i-mz.123-10.bin' is too large for available memory (4217920 bytes).boot of "tftp:192.168.1.101" using boot helper "flash:c2600-i-mz.123-10.bin" failed
error returned: File read failed -- Not enough space
loadprog: error - on file open
boot: cannot load "tftp:192.168.1.101"
System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2001 by cisco Systems, Inc.
C2600 platform with 32768 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0x74c534
Self decompressing the image : ########################################################################################################################## [OK]
