I want to use the RV082 WAN1 to connect to NBN FTTC (National broadband network Fire to the curb ) and WAN2 connecting to a 4G wireless service.
My problem is no internet connection on WAN1 I will configure WAN2 in the future.
My understanding is FTTC is your basic DSLAM hardware.
I have set up the RV082 as a router with PPPoE added the username and password (supplied from my service provider).
The NBN Modem is connecting, however the RV082 is not showing a WAN1 IP address, I think this is the issue.
I cant see anywhere to add a manual IP under PPPoE so I assume its all done automatically once the hand shaking is concluded successfully.
I'm not sure what to check from here ?