Command to reload an ATM route processor module

[axa-wongjeff]

The redundant route processor (RP) module on an 8540 ATM switch must have crashed. It is probably in rommon mode. I'm pretty sure the command does not exist, but is there a way I can reset the RP module alone? The equivalent would be on a Cat6500 'reload <module>' command. I'm not up to driving many miles to reseat the module or console into it.

[carenas123]

When the configuration register is set for manual booting, issuing the reload command causes the system to enter ROM monitor mode, where you enter the boot command and the name of the system image to use.Refer the following URL for more information

http://cisco.com/en/US/products/hw/switches/ps718/products_quick_start_chapter09186a00800f029d.html#wp1017074