Conditional NAT

pushpak.lele · ‎04-02-2014

Hi,

We need to implememt conditional nat in a test setup.

Please refer attched ppt for the diagram.

Kindly let us kow how this can be configured cause we tried using route-map with deny statement but its not working.

Please help

Thanks And Regards

Pushpak

paul driver · ‎04-02-2014

Hello

What is it you want to NAT?

Res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

pushpak.lele · ‎04-02-2014

Hi,

From R5 i will try toaccess 10.9.22.1 with source 10.1.1.1 in this 10.9.22.1 should get translated to 10.8.55.1. ( For 10.9.22.1 10.8.55.1 should reply )

From R5 i will try to access 10.9.22.1 with source 10.1.1.2 in this should 10.9.22.1 should go untranslated . ( 10.9.22.1 will reply ).

Thanks And Regards

Pushpak

paul driver · ‎04-03-2014

Hello

10.8.55.1 is located on r1 so why do you wish to NAT sourced from an ip on r5 using r1 IP address when communicating to an IP address on R2?

res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul