Need some advice on the following. Have 2 data centers currently active/standby and am looking to advertise the same /24 prefixes from both locations in case a DC is lost. Currently not an option to use something like GTM in an active/active type scenario.
Current setup is as following : Redundant firewalls/routers/load balancers etc.
Web and FTP Farms
Public /24 prefix advertised via BGP to internet. Inbound traffic routed from edge routers to external FW's and natted to VIP(s) on Loadbalancer. Server Poolsl sitting behind another layer of Internal firewalls. All addressing behind edge routers is RFC1918
DC1 and DC2 connected via 2 x 10G links with OSPF routing on Nexus 5596's.
In order to avoid complex routing/NAT would the easiest way to do this maybe to create some kind of wan backbone between the edge routers and DC1/DC2 core 5596 routers using some kind of traffic seperation mechanism ( vrf's etc. ) so same stateful devices can then process return traffic.
Any documents/links to similar setup would be helpful.
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...