diagram problem

eng_adel273 · ‎11-03-2017

Kindly find network diagram & problem

Julio E. Moisa · ‎11-03-2017

Hi

I have noted this behavior using the vlan 1 (default) only and no other VLANs, try configuring trunk interfaces between the Switch 1 and other switches and layer 3 port between Firewall and Switch 1.

Hope it is useful

:-)

>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

paul driver · ‎11-03-2017

This is a Duplicate post with the below

https://supportforums.cisco.com/t5/wan-routing-and-switching/auto-disconnecting-after-some-time/m-p/3208709#M287335

please close

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul