DMVPN QoS configuration on Hub and Spoke doesn't support nhrp group name on 2800 device

[Yogesh Choudhary]

Hello Experts,

I am working on implementing DMVPN QoS on one of my client network and I came across a problem in configuring nhrp groups at spoke side on 2800 device

On the DMVPN tunnel interface config is:

#ip nhrp map group group-name service-policy output qos_policy-map_name

On the branch tunnel interface, ip nhrp group group-name command doesn't support

Following is the version:

##Cisco IOS Software, 2801 Software (C2801-ADVIPSERVICESK9-M), Version 12.4(21), RELEASE SOFTWARE (fc1)

Need help please.

Thanks

Yogesh

[Joseph W. Doherty]

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Believe that's a newer IOS feature.  I recall it's first found in one of the 12.4T releases.