cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
686
Views
0
Helpful
0
Replies

Dynamic NAT Failover ASA

paulohenirque
Level 1
Level 1

Hy everyone  ,

Im having a bit of a doubt , i managed to configure a failover interface but im having problem changing my dynamic NAT from the inside interface , instead of outside it should be outside2 wich is my bkp interface , if i change it the internet works , but is there a way to get this to change automagicly ? And what about my static NAT rules they too are in my outside interface .

Thanks in advance .

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco