E1 Module

[justanas1]

dear Sir

i want to know what is the difference in the functionalty in the following type of E1 mofules:

VWIC-1MFT-E1 and NM-1CE1T1-PRI

Thanks alot

[vijayasankar]

Hi,

The module VWIC-1MFT-E1, is specific for terminating only a E1 link.

This module is limited in its capability to use every single DS0( 64 kbps) channels available in a E1.

The module NM-1CE1T1-PRI is a very flexible module in which you can either terminate a PRI line or a Channelized E1 line or a Channelized T1 line. Software configuration option will be available to select in which mode you want to use this module.

Also in this module, when using in channelized E1/T1 module, you can have more granular control on using any specific Ds0(64kbps) channel.

For details on NM-1CE1T1-PRI module visit this URL

http://www.cisco.com/warp/public/cc/pd/rt/2600/prodlit/ce1t1_ds.pdf

For details on VWIC-1MFT-E1 module visit this URL. Check out the VWIC Feature Comparison table in that page.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html

Hope this helps. Revert back if you need further clarifications. Kindly Rate the post if it was helpful

-VJ

[justanas1]

Thak you sir,

i want to know if the VWIC-1MFT-E1 support multi channel configuration to connect more sites

thanks

[vijayasankar]

Hi,

No. I dont think so.

In VWIC-1MFT-E1 you can have a max of two channel groups.

Have a look at this URL.

http://www.cisco.com/en/US/products/hw/routers/ps221/products_data_sheet09186a0080088715.html

-VJ

[albert.remo]

Hi!

Good day! Generally, VWIC supports voice while the other does not directly support voice. Versatility is another factor, VWIC is more versatile than the other. Please see links for a more in depth description:

VWIC-1MFT-E1

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html

NM-1CE1T1-PRI

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet09186a0080189f95.html

Hope this helps,

Regards,

Albert