Routing

Hi Expets!Sorry about this Question!i need Software for Trouble Ticketing;10xs for ur Help

I have a 871 with a single Internet connection DSL with Public static IP on both modem(DSL)and Router 2 VPN's are also working .What I want to do is to seperate the load I mean to say if one ISP goes down the other should work as I have another Inter...

Hi all,Given two equal distance AS Paths I would like to prefer one over the other. What is the best mechanism to implement this functionality? If one AS Path is shorter than another I want this path to be preferred regardless.Thanks in advance,Max

Can you use mac adder in an access list. Protocol EIGRP

Hi all,I would like to set profiles on my router (6509 w/ Sup720 3BXL) to restrict outbound routes based on the source IP address. I.e. if I have three upstream providers (ISP A, B, and C) I would like to configure 10.0.0.0/24 to use ISP A and B but ...

Hi, allIm quite new to learning VLANS etc. What I want to know is - What is the best basic cable configuration to use to use ISL\VLANs between two 21 port Cisco switches?Also how would you connect three switches?Regards

Is this possible? routerA connects to routerB witch connects to routerC and back to routerA. RouterA connects to the WAN or (internet) Each router has three interfaces. The loop is for redundancy in case of a circuit outage. All routers run OSPF. rou...

Hi experts,I want to share a problem I encounter. What is a possible causes if I can trace an IP (server) from a branch to HQ, but I can't ping it and use it. This occur only for 1 branch during an ISDN call, other branch are OK even when it using IS...

Hi all,Does anyone has a logical explanation for why in the case of having auto-summary enabled under BGP, the redistribution only injects the classful network, while the network command injects both the exact match subnet plus the classful network, ...

hi, i have the atach confirud in my router for working with BGP, i has tow service provider when one of then get 100% of bandwich i the other is 20 % more or less i want to use the both in the same i mean load balance can some one suggest something t...

Have had ongoing performance issues with a few of our T1 sites. Each branch office has a 2811 router which connects via a VPN tunnel to a 3005 VPN concentrator. When I run a test FTP script, the uploads are faster than the downloads. Any ideas on ...

We have set up 2 routers to test each end of a T1 circuit. We tested these routers succesfully on a T1 circuit, but when we switched them to a newly-provisioned T1, we were no longer able to ping. We receive "TTL expired in transit" messages. The ...

I am configuring an 827 router and do: ip address 192.168.0.1 255.255.255.0thencopy running-config startup-configHowever, there is a DHCP server running on the inside network, and after a few minutes eth0 takes its IP address from DHCP inspite of hav...