02-08-2016 09:19 AM - edited 03-05-2019 03:17 AM
Hello,
When EoMPLS packet goes over Etherchannel link than (as I can remember) algorithm for loadbalance hashning uses VC label.
So If I have only one VC than only one link will be used (even though this VC transports a huge amount od src and dst IP addresses).
Is there a way to configure loadbalancing method to be IP (srcIP,dstIP) for MPLS packets (to force switch not to use MPLS labels for loadbalancing decision, i.e. for 7600, 3750 platforms or it is hardcoded)?
Thanks in advance,
A.
02-08-2016 07:13 PM
I don't think so.
EtherChannel load balancing can use MPLS Layer 2 information
02-26-2016 05:31 AM
Thanks you.
regards,
A.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide